TY - JOUR AU - Nwakuba, Nnaemeka R. PY - 2019/07/24 Y2 - 2024/03/28 TI - Optimisation of energy consumption of a solar-electric dryer during hot air drying of tomato slices JF - Journal of Agricultural Engineering JA - J Agric Eng VL - 50 IS - 3 SE - Original Articles DO - 10.4081/jae.2019.876 UR - https://www.agroengineering.org/jae/article/view/876 SP - 150-158 AB - <p>High-energy demand of convective crop dryers has prompted study on optimisation of dryer energy consumption for optimal and cost effective drying operation. This paper presents response surface optimisation of energy consumption of a solar-electric dryer during hot air drying of tomato slices. Drying experiments were conducted with 1 kg batch of tomato samples using a 33 central composite design of Design Expert 7.0 Statistical Package. Three levels of air velocity (1.0, 1.5 and 2.0 ms<sup>–1</sup>), slice thickness (10, 15 and 20 mm) and air temperature (50, 60 and 70°C) were used to investigate their effects on energy consumption. A quadratic model was obtained with a high coefficient of determination (R<sup>2</sup>) of 0.9825. The model was validated using the statistical analysis of the experimental parameters and normal probability plot of the energy consumption residuals. Results obtained indicate that the process parameters had significant quadratic effects (P&lt;0.05) on the energy consumption. The energy consumption varied between 5.42 kWh and 99.78 kWh; whereas the specific energy consumption varied between 5.53 kWhkg<sup>–1</sup> and 150.61 kWhkg<sup>–1</sup>. The desirability index method was applied in predicting the ideal energy consumption and drying conditions for tomato slices in a solar-electric dryer. At optimum drying conditions of 1.94 ms<sup>–1</sup> air velocity, 10.36 mm slice thickness and 68.4°C drying air temperature, the corresponding energy consumption was 5.6 8kWh for maximum desirability index of 0.989. Thermal utilisation efficiency (TUE) of the sliced tomato samples ranged between 15 ≤TUE ≤58%. The maximum TUE value was obtained at 70°C air temperature, 1.0 ms<sup>–1</sup> air velocity and 10 mm slice thickness treatment combination, whereas the minimum TUE was obtained at 50°C air temperature, 2.0 ms<sup>–1</sup> air velocity and 20 mm slice thickness. Recommendation and prospect for further improvement of the dryer system were stated.</p> ER -