https://doi.org/10.4081/jae.2020.1057
Improving olive mechanical harvesting using appropriate natural frequency
Published: 29 September 2020
Abstract Views: 1063
PDF: 666
HTML: 639
HTML: 639
Publisher's note
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
Authors
The good performance of olive mechanical harvesting by shaking depends on the suitable values of limb vibrator operating parameters (frequency and amplitude). Mathematical models of a single degree of freedom (S.D.F.M) and two degrees of freedom (T.D.F.M) were used to estimate the natural frequency (FN) of olive fruit stem system. The results from these models indicated that the FN values were 33.9, 31.9, and 28.0 Hz for the full mature stage, half-ripe olive, and full-ripe olive respectively. Branch vibrator was operated at three levels of frequency 25, 30 and 35 Hz and 3 levels of amplitude 25, 30 and 35 mm at a vibration time of 10 s. Measurements covered the fruit removal percentage (FRP) and degree of full-ripe fruit selectivity (DS). The results showed that the maximum FRP value, 90.6%, was achieved at a frequency of 35 Hz and amplitude of 25 mm while the maximum DS value, 78.58%, was obtained at 25 Hz frequency and 25 mm amplitude.
Aiello G, Vallone M, Catania P, 2019. Optimising the efficiency of olive harvesting considering operator safety. Biosystems Engineering. Volume 185, 15-24.
DOI: https://doi.org/10.1016/j.biosystemseng.2019.02.016
Bacenetti J, De Luca AI, 2018. Harvesting system sustainability in Mediterranean olive cultivation. Sci. Total. Environ. 625:1446-58.
DOI: https://doi.org/10.1016/j.scitotenv.2018.01.005
Castro-GarcÃa S, Castillo-Ruiz FJ, Sola-Guirado RR, Jiménez-Jiménez F, Blanco-Roldán GL, AgüeraVega J, Gil-Ribes JA, 2014. Table olive response to harvesting by trunk shaker, International Conference on Agricultural Engineering, ref. C0662, 6-10 July, Zurich, Switzerland.
Cicek G, 2011. Determination of harvesting costs and cost analysis for different olive harvesting methods. Journal of Food, Agriculture & Environment Vol.9 (3&4): 201- 204.
Ciro VHJ, 2001. Coffee harvesting I: Determination of the natural frequencies of the fruit stem system in coffee trees. Applied Engineering in Agriculture of the ASAE 17(4): 475– 479.
DOI: https://doi.org/10.13031/2013.6464
Ghonimy MI, 2006. Prediction of the suitable amplitude of shaking unit for fruit harvesting. Misr J. Ag. Eng., 23(1): 1-18.
Ghonimy MI, Alzoheiry AM, Abd El Rahman EN, 2019. Citrus harvesting by vibrating action. Misr J. Ag. Eng., 36(1): 25-36.
DOI: https://doi.org/10.21608/mjae.2019.94438
Hoshyarmanesh H, Dastgerdi HR, Ghodsi M, Khandan R, Zareinia K, 2017. Numerical and experimental vibration analysis of olive tree for optimal mechanized harvesting efficiency and productivity. Computers and Electronics in Agriculture, 132, 34-48.â€
DOI: https://doi.org/10.1016/j.compag.2016.11.014
Leone A, Romaniello R, Tamborrino A, Catalano P, Peri G, 2015. Identification of vibration frequency, acceleration, and duration for efficient olive harvesting using a trunk shaker. Transactions of the ASABE, 58(1):1–8.
Martinez A, 1977. Estudio teórico de la dinámica del sistema fruto pedúnculo. Revista Ciencias Técnicas. Serie construcción de maquinaria. Instituto Superior Politécnico José Antonio EcheverrÃa, Habana, Cuba. Octubre. 14-16 pp.
Mayans Céspedes PR, Cansteñs L, de Jesús G, Romanchik Kriuchkova E, Pérez Sobrevilla L, 2016. Modelación matemática del sistema fruto-pedicelo-pedúnculo del mango Manila (Mathematical modeling system of the fruit-pedicel-peduncle Manila mango). Revista mexicana de ciencias agrÃcolas, 7(4), 781-791
DOI: https://doi.org/10.29312/remexca.v7i4.253
Öztekin YB, Güngör B, 2020. Determining impact-bruising thresholds of peaches using electronic fruit. Scientia Horticulturae, 262, 109046.â€
DOI: https://doi.org/10.1016/j.scienta.2019.109046
Tinoco HA, 2017. Modeling elastic and geometric properties of Coffea arabica L. var. Colombia fruits by an experimental-numerical approach. International Journal of Fruit Science, 17(2), 159-174.
DOI: https://doi.org/10.1080/15538362.2016.1270249
Tornabene F, Fantuzzi N, Bacciocchi M, 2017. Mechanical behaviour of composite Cosserat solids in elastic problems with holes and discontinuities. Composite Structures, 179, 468-481.â€
DOI: https://doi.org/10.1016/j.compstruct.2017.07.087
Villibor GP, Santos FL, de Queiroz DM, Júnior JKK, de Carvalho Pinto FDA, 2016. Determination of modal properties of the coffee fruit-stem system using high-speed digital video and digital image processing. Acta Scientiarum. Technology, 38(1), 41-48.†Doi: 10.4025/actascitechnol.v38i1.27344.
DOI: https://doi.org/10.4025/actascitechnol.v38i1.27344
Zipori I, Dag A, Tugendhaft Y, Birger R, 2014. Mechanical Harvesting of Table Olives: Harvest Efficiency and Fruit Quality, Hortscience, 49(1), 55-58.
DOI: https://doi.org/10.21273/HORTSCI.49.1.55
How to Cite
Alzoheiry, A. (2020) “Improving olive mechanical harvesting using appropriate natural frequency”, Journal of Agricultural Engineering, 51(3), pp. 148–154. doi: 10.4081/jae.2020.1057.
PAGEPress has chosen to apply the Creative Commons Attribution NonCommercial 4.0 International License (CC BY-NC 4.0) to all manuscripts to be published.
Similar Articles
- Alessio Cappelli, Lucrezia Lupori, Enrico Cini, Should extra virgin olive oil production change the approach? A systematic review of challenges and opportunities to increase sustainability, productivity, and product quality , Journal of Agricultural Engineering: Vol. 54 No. 1 (2023)
- Maria Lisa Clodoveo, Tiziana Dipalmo, Cristina Schiano, Domenico La Notte, Sandra Pati, What’s now, what’s new and what’s next in virgin olive oil elaboration systems? A perspective on current knowledge and future trends , Journal of Agricultural Engineering: Vol. 45 No. 2 (2014)
- Angela Calvo, Roberto Deboli, Christian Preti, Antonino De Maria, Daily exposure to hand arm vibration by different electric olive beaters , Journal of Agricultural Engineering: Vol. 45 No. 3 (2014)
- Francesca Valenti, Simona M.C. Porto, Giovanni Cascone, Claudia Arcidiacono, Potential biogas production from agricultural by-products in Sicily. A case study of citrus pulp and olive pomace , Journal of Agricultural Engineering: Vol. 48 No. 4 (2017)
- Tullia Gallina Toschi, Annachiara Berardinelli, Chiara Cevoli, Eleonora Iaccheri, Giuseppe Di Lecce, Alessandra Bendini, Luigi Ragni, Effectiveness of the mechanical excitation applied to the olive paste: possible improving of the oil yield, in malaxation phase, by vibration systems , Journal of Agricultural Engineering: Vol. 44 No. 4 (2013)
- Ziyan Fan, Lijun Li, Zicheng Gao, Fuzzy neural network PID control design of camellia fruit vibration picking manipulator , Journal of Agricultural Engineering: Vol. 54 No. 2 (2023)
- Xiaoqiang Du, Tengfei Shen, Kaizhan Chen, Guofeng Zhang, Xiaohua Yao, Juanjuan Chen, Yongqing Cao, Simulation study and field experiments on the optimal canopy shaking action for harvesting Camellia oleifera fruits , Journal of Agricultural Engineering: Vol. 53 No. 3 (2022)
- Abderrahman Sghaier, Hanen Dhaou, Lassaad Jarray , Zouhair Abaab, Ahmed Sekrafi, Mohamed Ouessar , Assessment of drought stress in arid olive groves using HidroMORE model , Journal of Agricultural Engineering: Vol. 53 No. 1 (2022)
- Domenico Pessina, Davide Facchinetti, Valentina Bonalume, Evaluation of the efficiency of systems to reduce vibration on modern tracklaying tractors , Journal of Agricultural Engineering: Vol. 43 No. 1 (2012)
- Angelo Fabbri, Chiara Cevoli, Giuseppe Cantalupo, A method for handlebars ballast calculation in order to reduce vibrations transmissibility in walk behind tractors , Journal of Agricultural Engineering: Vol. 48 No. 2 (2017)
You may also start an advanced similarity search for this article.
