https://doi.org/10.4081/jae.2022.1339
Portable central baffle flume
Published: 29 June 2022
Abstract Views: 665
PDF: 302
HTML: 58
HTML: 58
Publisher's note
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
Authors
This paper investigated the hydraulic characteristics of the triangular central baffle (TCB) flume. Laboratory tests were carried out to determine the flume dimensions. The field applicability of the proposed portable device was examined by on-farm installation. According to the laboratory tests, when the contraction ratio, r, was less than 0.39, the flow capacity was not affected by the ratio between the flume’s floor height and the throat width. The laboratory analysis also showed that there was no significant effect of installing an entrance ramp on the stage-discharge relationship for r<0.39, while the entrance ramp increased the discharge capacity for r>0.39. The stage-discharge curve obtained based on the laboratory tests was verified using field data. The results revealed that the proposed portable flume could be used accurately to determine the flow through an unlined ditch. Practical suggestions were proposed to determine the distinguishing condition curve.
Barenblatt G.I. 1979. Similarity, self-similarity and intermediate asymptotics. Consultants Bureau, NY, USA.
DOI: https://doi.org/10.1007/978-1-4615-8570-1
Barenblatt G.I. 1987. Dimensional analysis. Gordon & Breach, Science Publishers, Amsterdam, The Netherlands.
Bijankhan M., Ferro V. 2019. Experimental study on triangular central baffle flume. Flow Measure. Instrum. 101641.
DOI: https://doi.org/10.1016/j.flowmeasinst.2019.101641
Bos M.G. 1989. Discharge measurement structures. International Institute for Land Reclamation and Improvement/ILRI.
De Martino G., Ragone A. 1984. Effects of viscosity and surface tension on slot weirs flow. J. Hydr. Res. 22:327-41.
DOI: https://doi.org/10.1080/00221688409499369
Ferro V. 2016. Simple flume with a central baffle. Flow Measure. Instrum. 52:53-6.
DOI: https://doi.org/10.1016/j.flowmeasinst.2016.09.006
Ferro V. 2018. Discussion of "Three Simple Flumes for Flow Measurement in Open Channels" by Zohrab Samani. J. Irrig. Drain. Engine. 144:8-9.
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001323
Hager W.H. 1985. Modified venturi channel. J. Irrig. Drain. Engine. 111:19-35.
DOI: https://doi.org/10.1061/(ASCE)0733-9437(1985)111:1(19)
Hager W.H. 1989. Mobile flume for circular channel. J. Irrig. Drain. Engine. 114:520-34.
DOI: https://doi.org/10.1061/(ASCE)0733-9437(1988)114:3(520)
Kapoor A., Ghare A.D., Vasudeo A.D., Badar A.M. 2019. Channel flow measurement using portable conical central baffle. J. Irrig. Drain. Engine. 145:06019010.
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001427
Lotfi Kolavani F., Bijankhan M., Di Stefano C., Ferro V., Mazdeh A.M. 2019. Experimental study of central baffle flume. J. Irrig. Drain. Engine. 145(3).
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001370
Peruginelli A., Bonacci F. 1995. Funzionamento libero e sommerso di un misuratore di portata a risalto idraulico. Idrotecnica. Sept-Dec:261-72 [In Italian].
Samani Z. 2017. Three simple flumes for flow measurement in open channels. J. Irrig. Drain. Engine. 143:2-5.
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001168
Samani Z., Jorat S., Yousef M. 1991. Hydraulic characteristics of circular flume. J. Irrig. Drain. Engine. 117:558-66.
DOI: https://doi.org/10.1061/(ASCE)0733-9437(1991)117:4(558)
Sargison E.J. 1972. The influence of surface tension on weir flow. J. Hydr. Res. 10:431-46.
DOI: https://doi.org/10.1080/00221687209500034
Ranga Raju K.G., Asawa G.L. 1977. Viscosity and surface tension effects on weir flow. J. Hydr. Division ASCE. 103:1227-31.
DOI: https://doi.org/10.1061/JYCEAJ.0004857
Rao S.S., Shukla M.J. 1971. Characteristics of flow over weirs of finite crest width. J. Hydr. Division ASCE. 97:1807-16.
DOI: https://doi.org/10.1061/JYCEAJ.0003138
How to Cite
Bijankhan, M., Teymourkhani, A. and Ferro, V. (2022) “Portable central baffle flume”, Journal of Agricultural Engineering, 53(2). doi: 10.4081/jae.2022.1339.
Copyright (c) 2022 the Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
PAGEPress has chosen to apply the Creative Commons Attribution NonCommercial 4.0 International License (CC BY-NC 4.0) to all manuscripts to be published.
Similar Articles
- Irene Diti, Daniele Torreggiani, Patrizia Tassinari, Rural landscape and cultural routes: a multicriteria spatial classification method tested on an Italian case study , Journal of Agricultural Engineering: Vol. 46 No. 1 (2015)
- Pietro Catania, Filippa Bono, Claudio De Pasquale, Mariangela Vallone, Closed tank pneumatic press application to improve Sauvignon Blanc wine quality and nutraceutical properties , Journal of Agricultural Engineering: Vol. 50 No. 4 (2019)
- Artur Altunyan, Arshaluys Tarverdyan, Geometric and kinematic parameters of vibrating knife in the development of cutting machines , Journal of Agricultural Engineering: Vol. 52 No. 3 (2021)
- Ernest Ekow Abano, Livingston Kobina Sam-Amoah, Ato Bart-Plange, Variation in ultrasonic frequency and time as pre-treatments to air-drying of carrot , Journal of Agricultural Engineering: Vol. 43 No. 4 (2012)
- Daniele Duca, Giuseppe Toscano, Andrea Pizzi, Giorgio Rossini, Sara Fabrizi, Giulia Lucesoli, Andrea Servili, Valeria Mancini, Gianfranco Romanazzi, Chiara Mengarelli, Evaluation of the characteristics of vineyard pruning residues for energy applications: effect of different copper-based treatments , Journal of Agricultural Engineering: Vol. 47 No. 1 (2016)
- Salvatore Faugno, Stefania Pindozzi, Collins Okello, Maura Sannino, Testing the application of an automatic milking system on buffalo (Bubalus bubalis) , Journal of Agricultural Engineering: Vol. 46 No. 1 (2015)
- Natalia Fumagalli, Claudia Colombo, Paolo Stefano Ferrario, Giulio Senes, Alessandro Toccolini, Suburban waterfront with ecological and recreational function: planning based on network analysis , Journal of Agricultural Engineering: Vol. 44 No. 4 (2013)
- Roberto Beghi, Valentina Giovenzana, Raffaele Civelli, Enrico Cini, Riccardo Guidetti, Characterisation of olive fruit for the milling process by using visible/near infrared spectroscopy , Journal of Agricultural Engineering: Vol. 44 No. 2 (2013)
- Andrey Linenko, Bulat Khalilov, Timur Kamalov, Marat Tuktarov, Damir Syrtlanov, Effective technical ways to improve the vibro-centrifugal separator electric drive for grain cleaning , Journal of Agricultural Engineering: Vol. 52 No. 2 (2021)
- Paolo Barge, Paolo Gay, Valentina Merlino, Cristina Tortia, Passive ultra high frequency radio frequency identification systems for single-item identification in food supply chains , Journal of Agricultural Engineering: Vol. 48 No. 1 (2017)
<< < 14 15 16 17 18 19 20 21 22 23 > >>
You may also start an advanced similarity search for this article.
