https://doi.org/10.4081/jae.2022.1339
Portable central baffle flume
Published: 29 June 2022
Abstract Views: 665
PDF: 302
HTML: 58
HTML: 58
Publisher's note
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
Authors
This paper investigated the hydraulic characteristics of the triangular central baffle (TCB) flume. Laboratory tests were carried out to determine the flume dimensions. The field applicability of the proposed portable device was examined by on-farm installation. According to the laboratory tests, when the contraction ratio, r, was less than 0.39, the flow capacity was not affected by the ratio between the flume’s floor height and the throat width. The laboratory analysis also showed that there was no significant effect of installing an entrance ramp on the stage-discharge relationship for r<0.39, while the entrance ramp increased the discharge capacity for r>0.39. The stage-discharge curve obtained based on the laboratory tests was verified using field data. The results revealed that the proposed portable flume could be used accurately to determine the flow through an unlined ditch. Practical suggestions were proposed to determine the distinguishing condition curve.
Barenblatt G.I. 1979. Similarity, self-similarity and intermediate asymptotics. Consultants Bureau, NY, USA.
DOI: https://doi.org/10.1007/978-1-4615-8570-1
Barenblatt G.I. 1987. Dimensional analysis. Gordon & Breach, Science Publishers, Amsterdam, The Netherlands.
Bijankhan M., Ferro V. 2019. Experimental study on triangular central baffle flume. Flow Measure. Instrum. 101641.
DOI: https://doi.org/10.1016/j.flowmeasinst.2019.101641
Bos M.G. 1989. Discharge measurement structures. International Institute for Land Reclamation and Improvement/ILRI.
De Martino G., Ragone A. 1984. Effects of viscosity and surface tension on slot weirs flow. J. Hydr. Res. 22:327-41.
DOI: https://doi.org/10.1080/00221688409499369
Ferro V. 2016. Simple flume with a central baffle. Flow Measure. Instrum. 52:53-6.
DOI: https://doi.org/10.1016/j.flowmeasinst.2016.09.006
Ferro V. 2018. Discussion of "Three Simple Flumes for Flow Measurement in Open Channels" by Zohrab Samani. J. Irrig. Drain. Engine. 144:8-9.
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001323
Hager W.H. 1985. Modified venturi channel. J. Irrig. Drain. Engine. 111:19-35.
DOI: https://doi.org/10.1061/(ASCE)0733-9437(1985)111:1(19)
Hager W.H. 1989. Mobile flume for circular channel. J. Irrig. Drain. Engine. 114:520-34.
DOI: https://doi.org/10.1061/(ASCE)0733-9437(1988)114:3(520)
Kapoor A., Ghare A.D., Vasudeo A.D., Badar A.M. 2019. Channel flow measurement using portable conical central baffle. J. Irrig. Drain. Engine. 145:06019010.
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001427
Lotfi Kolavani F., Bijankhan M., Di Stefano C., Ferro V., Mazdeh A.M. 2019. Experimental study of central baffle flume. J. Irrig. Drain. Engine. 145(3).
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001370
Peruginelli A., Bonacci F. 1995. Funzionamento libero e sommerso di un misuratore di portata a risalto idraulico. Idrotecnica. Sept-Dec:261-72 [In Italian].
Samani Z. 2017. Three simple flumes for flow measurement in open channels. J. Irrig. Drain. Engine. 143:2-5.
DOI: https://doi.org/10.1061/(ASCE)IR.1943-4774.0001168
Samani Z., Jorat S., Yousef M. 1991. Hydraulic characteristics of circular flume. J. Irrig. Drain. Engine. 117:558-66.
DOI: https://doi.org/10.1061/(ASCE)0733-9437(1991)117:4(558)
Sargison E.J. 1972. The influence of surface tension on weir flow. J. Hydr. Res. 10:431-46.
DOI: https://doi.org/10.1080/00221687209500034
Ranga Raju K.G., Asawa G.L. 1977. Viscosity and surface tension effects on weir flow. J. Hydr. Division ASCE. 103:1227-31.
DOI: https://doi.org/10.1061/JYCEAJ.0004857
Rao S.S., Shukla M.J. 1971. Characteristics of flow over weirs of finite crest width. J. Hydr. Division ASCE. 97:1807-16.
DOI: https://doi.org/10.1061/JYCEAJ.0003138
How to Cite
Bijankhan, M., Teymourkhani, A. and Ferro, V. (2022) “Portable central baffle flume”, Journal of Agricultural Engineering, 53(2). doi: 10.4081/jae.2022.1339.
Copyright (c) 2022 the Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
PAGEPress has chosen to apply the Creative Commons Attribution NonCommercial 4.0 International License (CC BY-NC 4.0) to all manuscripts to be published.
Similar Articles
- Alvaro Marucci, Adolfo Gusman, Barbara Pagniello, Andrea Cappuccini, Limits and prospects of photovoltaic covers in Mediterranean greenhouses , Journal of Agricultural Engineering: Vol. 44 No. 1 (2013)
- Francesco Giuseppe Carollo, Vito Ferro, Vincenzo Pampalone, Sequent depth ratio of B-jumps on smooth and rough beds , Journal of Agricultural Engineering: Vol. 44 No. 2 (2013)
- Carlos Alejandro Perez Garcia, Marco Bovo, Daniele Torreggiani, Patrizia Tassinari, Stefano Benni, 3D numerical modelling of temperature and humidity index distribution in livestock structures: a cattle-barn case study , Journal of Agricultural Engineering: Vol. 54 No. 3 (2023)
- Emanuele Cerruto, FURTHER STUDIES ON THE VARIATION OF SPRAY DEPOSITS IN VINEYARDS WITH AIRFLOW RATE AND VOLUME RATE , Journal of Agricultural Engineering: Vol. 38 No. 1 (2007)
- Francesca Piazzolla, Maria Luisa Amodio, Giancarlo Colelli, The use of hyperspectral imaging in the visible and near infrared region to discriminate between table grapes harvested at different times , Journal of Agricultural Engineering: Vol. 44 No. 2 (2013)
- Zhiqiang Song, Chuanxing Du, Yongcheng Chen, Dianlei Han, Xinzhong Wang, Development and test of a spring-finger roller-type hot pepper picking header , Journal of Agricultural Engineering: Vol. 55 No. 2 (2024)
- Lorenzo Vergni, Alessandra Vinci, Francesca Todisco, Francesco Saverio Santaga, Marco Vizzari, Comparing Sentinel-1, Sentinel-2, and Landsat-8 data in the early recognition of irrigated areas in central Italy , Journal of Agricultural Engineering: Vol. 52 No. 4 (2021)
- Ferruccio Giametta, Flavio Fucci, Pasquale Catalano, Giovanna La Fianza, Thermo-fluid-dynamic modelling of a cold store for cheese maturation , Journal of Agricultural Engineering: Vol. 43 No. 4 (2012)
- Costanza Di Stefano, Vito Ferro, Establishing soil loss tolerance: an overview , Journal of Agricultural Engineering: Vol. 47 No. 3 (2016)
- Aldo Calcante, Francesco M. Tangorra, Measuring oxygen saturation and pulse rate in dairy cows before and after machine milking using a low-cost pulse oximeter , Journal of Agricultural Engineering: Vol. 52 No. 2 (2021)
<< < 1 2 3 4 5 6 7 8 9 10 > >>
You may also start an advanced similarity search for this article.
