https://doi.org/10.4081/jae.2023.1541
Design and experiment of brush-roller ginkgo leaf picker for the dwarf dense planting mode
Published: 25 October 2023
Abstract Views: 1020
PDF: 317
HTML: 18
HTML: 18
Publisher's note
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
All claims expressed in this article are solely those of the authors and do not necessarily represent those of their affiliated organizations, or those of the publisher, the editors and the reviewers. Any product that may be evaluated in this article or claim that may be made by its manufacturer is not guaranteed or endorsed by the publisher.
Authors
At present, ginkgo leaves are still picked manually. A brush roller ginkgo leaf picker has been designed to improve harvesting efficiency and reduce losses caused by manual failure to pick leaves in time under large-scale planting areas. The ginkgo leaf picker is mainly composed of crawler chassis, gantry frame, brush roller picking parts, and collecting box. The kinematics of the brush roller are analyzed for the picking omission situation. An experimental platform for picking ginkgo biloba leaves was established. Three parameters, namely roller speed, moving speed, and roller inclination were selected for optimization. Then the maximum net harvest rate and the minimum damage rate were achieved. The orthogonal test showed that when the roller speed was 130 rev/min, the moving speed was 0.25 m/s, and the roller inclination was 32°, the picking effect was the best, the net harvest rate was 93.32%, the damage rate was 1.42%, and the damage degree of the trunks was slight. The experiment proved that the brush-roller ginkgo leaf picker has a good picking effect, which can provide a reference for the optimization design of ginkgo leaf harvesting machinery under the dwarf dense planting mode.
Al-Adwani, DG., Renno, WM., Orabi, KY. 2019. Neurotherapeutic effects of Ginkgo biloba extract and its terpene trilactone, ginkgolide B, on sciatic crush injury model: A new evidence. Plos One. 1412:e0226626.
DOI: https://doi.org/10.1371/journal.pone.0226626
Guo, Y., Mao, MJ., Li, QY., Yu, XH., Zhou, LP. 2022. Extracts of Ginkgo flavonoids and ginkgolides improve cerebral ischaemia-reperfusion injury through the PI3K/Akt/Nrf2 signalling pathway and multicomponent in vivo processes. Phytomedicine : international journal of phytotherapy and phytopharmacology. 99:154028-154028.
DOI: https://doi.org/10.1016/j.phymed.2022.154028
Tang, DN., Tran, Y., Lewis, JR., Bondonno, NP., Bondonno, CP., Hodgson, JM., Domingo, D., McAlpine, D., Burlutsky, G., Mitchell, P. 2022. Associations between intake of dietary flavonoids and the 10-year incidence of tinnitus in older adults. European Journal of Nutrition. 614:1957-1964.
DOI: https://doi.org/10.1007/s00394-021-02784-w
Wang, SJ., Kang, AD., Liu, Q., Zhang, SJ., Tian, L., Zhou, W., Yun, F., Shan, JJ., Zhao XL., Bi, XL. 2013. Advances in Pharmacokinetics of Main Active Components in Ginkgo Biloba Extract. Chinese herbal medicine. 4405:626-631.
Wang, SJ., Yuan, TY., Zhang, JN. 2018. Research progress on the effects of ginkgo biloba extract and its active components on improving cognitive function. Research and development of natural products. 3010:1819-1824.
Yu AX. 2012. Market Demand and Development Strategy of Ginkgo. Modern agricultural science and technology. 24:190-191.
Zhou H., Wang CZ. 2021. Development Status of Ginkgo Resource Processing and Utilization Industry. Biomass Chemical Engineering. 5501:10-14.
Yang QX. 2013. Advantages of dwarf close planting cultivation of fruit ginkgo. Hebei Forestry Science and Technology. 05:94-95.
Kultongkham, A., Kumnon, S., Thintawornkul, T ; Chanthasopeephan, T. 2021. The design of a force feedback soft gripper for tomato harvesting. Journal of Agricultural Engineering. 1:1090.
DOI: https://doi.org/10.4081/jae.2021.1090
Hayashi, S., Shigematsu, K., Yamamoto, S., Kobayashi, K., Kohno, Y., Kamata, J., Kurita, M. 2010. Evaluation of a strawberry-harvesting robot in a field test. Biosystems Engineering. 1052:160-171.
DOI: https://doi.org/10.1016/j.biosystemseng.2009.09.011
Arad, B., Balendonck, J., Barth, R., Ben-Shahar, O., Edan, Y., Hellstrom, T., Hemming, J., Kurtser, P., Ringdahl, O., Tielen, T., van Tuijl, B. 2020. Development of a sweet pepper harvesting robot. Journal of Field Robotics. 376:1027-1039.
DOI: https://doi.org/10.1002/rob.21937
Oyedeji, AN., Umar, UA., Kuburi, LS., Abu Edet, A., Mukhtar, Y. 2022. Development and performance evaluation of an oil palm harvesting robot for the elimination of ergonomic risks associated with oil palm harvesting. Journal of Agricultural Engineering. 3:1388.
DOI: https://doi.org/10.4081/jae.2022.1388
Ota, T., Bontsema, J., Hayashi, S., Kubota, K., Van Henten, EJ., Van Os, EA., Ajiki, K. 2007. Development of a cucumber leaf picking device for greenhouse production. Biosystems Engineering. 984:381-390.
DOI: https://doi.org/10.1016/j.biosystemseng.2007.09.021
Hu YC., Yan XZ., Jin F., Mou XW., Liao W. 2016. Design of Reciprocating Mulberry Leaf Picker and Analysis of Picking Benefits. Research on Agricultural Mechanization: 3804: 76-79.
Yang DJ., Zhang CM., Yang CY., Zhu DG., Chen Q. 2017. Design of Spring Type Ginkgo Leaf Picker. Forestry Machinery and Woodworking Equipment. 4506:33-34.
Zhang S., Zhu DG., Chen Q., Xu YY., Zhu MJ. 2019. Design of ginkgo leaf harvesting mechanism. Forestry Machinery and Woodworking Equipment. 4701:17-19+25.
DJ Yang., JL Kong., XX Su. 2019. Design and Research of Ginkgo Leaves Retractable Picker. Applied Engineering. 32:134-139.
Bubola, M., Lukic, I., Radeka, S., Sivilotti, P., Grozic, K., Vanzo, A., Bavcar, D., Lisjak, K. 2019. Enhancement of Istrian Malvasia wine aroma and hydroxycinnamate composition by hand and mechanical leaf removal. Journal of the Science of Food and Agriculture. 99: 904-914.
DOI: https://doi.org/10.1002/jsfa.9262
Guidoni, S., Oggero, G., Cravero, S., Rabino, M., Cravero, MC., Balsari, P. 2008. Manual and mechanical leaf removal in the bunch zone (Vitis vinifera L., cv barbera): Effects on berry composition, health, yield and wine quality in a warm temperate area. Journal International des Sciences de la Vigne et du Vin. 42:49-58.
DOI: https://doi.org/10.20870/oeno-one.2008.42.1.831
Liu XM. 2019. Study on the Picking Mechanism of Horizontal Cotton Picker. Shihezi University, Xinjiang, China.
Xue Z. 2018. Mechanical Characteristics and Simulation Analysis of Cassava Stalk Cutting. Huazhong Agricultural University, Hubei, China.
Zhang, SW., Wang, ZL., Wang, L., Liu, S., Zhang, YJ., Miao, H., Dai, M., Liu, SX. 2021. Design and experimental study of ginkgo leaf picking device. Proceedings of the Institution of Mechanical Engineers Part C- Journal of Mechanical Engineering Science. 23524:7353-7362.
DOI: https://doi.org/10.1177/09544062211023118
Jan Vavro Jr., Jan Vavro., Petra Kovacikova., Radka Bezdedova. 2017. Kinematic and Dynamic Analysis of Planar Mechanisms by Means of the Solid Works Software. Procedia Engineering. 177:476-481.
DOI: https://doi.org/10.1016/j.proeng.2017.02.248
Li YK., Han ML. 2016. Dynamic Simulation Analysis of Large Rotary Amusement Equipment Based on SolidWorks Motion. Mechanical design and manufacturing. 03:51-53.
How to Cite
Zhang, S. (2023) “Design and experiment of brush-roller ginkgo leaf picker for the dwarf dense planting mode”, Journal of Agricultural Engineering, 54(4). doi: 10.4081/jae.2023.1541.
Copyright (c) 2023 the Author(s)
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
PAGEPress has chosen to apply the Creative Commons Attribution NonCommercial 4.0 International License (CC BY-NC 4.0) to all manuscripts to be published.
Similar Articles
- Timothy Denen Akpenpuun, Wook Ho Na, Qazeem Opeyemi Ogunlowo, Anis Rabiu, Misbaudeen Aderemi Adesanya, Kwame Sasu Addae, Hyeon Tae Kim, Hyun-Woo Lee, Effect of glazing configuration as an energy-saving strategy in naturally ventilated greenhouses for strawberry (Seolhyang sp.) cultivation , Journal of Agricultural Engineering: Vol. 52 No. 2 (2021)
- Angelo Fabbri, Chiara Cevoli, Giuseppe Cantalupo, A method for handlebars ballast calculation in order to reduce vibrations transmissibility in walk behind tractors , Journal of Agricultural Engineering: Vol. 48 No. 2 (2017)
- Andrea Peruzzi, Luisa Martelloni, Christian Frasconi, Marco Fontanelli, Michel Pirchio, Michele Raffaelli, Machines for non-chemical intra-row weed control in narrow and wide-row crops: a review , Journal of Agricultural Engineering: Vol. 48 No. 2 (2017)
- Vidas Damanauskas, Algirdas Janulevičius, Effect of tillage implement (spring tine cultivator, disc harrow), soil texture, forward speed, and tillage depth on fuel consumption and tillage quality , Journal of Agricultural Engineering: Vol. 53 No. 3 (2022)
- Wei Wang, Yuanjuan Gong, Xuewei Bai, Rui Tan, Real-time straw moisture content detection system for mobile straw granulator , Journal of Agricultural Engineering: Vol. 55 No. 2 (2024)
- Qazeem Opeyemi Ogunlowo, Adedayo Afeez Azeez, Wook Ho Na, Anis Rabiu, Misbaudeen Aderemi Adesanya, Ezatullah Zakir, John Ademola Ijadunola, Bukola Olanrewaju Afolabi, Babajide Saheed Kosemani, Titus Adeyinka Ilori, Hyun-Woo Lee, Analysis of microclimate temperature and relative humidity distribution of local poultry house in a subtropical area of Nigeria , Journal of Agricultural Engineering: Vol. 55 No. 2 (2024)
- Mauro Podrecca, Alessandro Chiumenti, Francesco Da Borso, Marco Contin, Maria De Nobili, Reduction of odorous compounds emissions from swine slurry by electrolytic treatments and copper addition , Journal of Agricultural Engineering: Vol. 48 No. 1 (2017)
- Elio Dinuccio, Fabrizio Gioelli, Dalibor Cuk, Luca Rollè, Paolo Balsari, The use of co-digested solid fraction as feedstock for biogas plants , Journal of Agricultural Engineering: Vol. 44 No. 4 (2013)
- Qazeem Opeyemi Ogunlowo, Wook Ho Na, Anis Rabiu, Misbaudeen Aderemi Adesanya, Timothy Denen Akpenpuun, Hyeon Tae Kim, Hyun Woo Lee, Effect of envelope characteristics on the accuracy of discretised greenhouse model in TRNSYS , Journal of Agricultural Engineering: Vol. 53 No. 3 (2022)
- Adisa A. Folami, Eberendu N. Obioha, Aderinlewo A. Adewole, Kuye S. Ibiyemi, Performance evaluation of a developed rice-processing machine , Journal of Agricultural Engineering: Vol. 47 No. 3 (2016)
<< < 1 2 3 4 5 6 7 8 9 10 > >>
You may also start an advanced similarity search for this article.
